How To's Aluminum Heads and Spark Plugs:Spark Plug seizure in an aluminum cylinder head is usually caused by improper... Tips for '32-'53 Flatheads: 1.Use valve grind compund to seat rear hubs on axles so taper fits tight and torque to... Transmission Technical Tips: 1. Test drive trans. before removal to determine repairs needed and parts to replace... Rebuilding Brake Cylinders: In order to properly distribute the hydrolic pressure so that the brake application... Rebuilding Flathead Water Pumps: The water pump used on 60H.P. engine (Fig.8) is held in the engine block by... Preparing for Upholstery: 1.Appointments : Call or get in touch with the upholstery shop well ahead of time to " get on the list"... Transmission Overhaul Tips: 1. Disassemble transmission.  2. Hot Tank all parts.  3. Check case for wear and...   How To's on Other Sites Installing Dual Carbs on a Flathead: Pretty much all the books on flatheads don't recommend more than dual 6 to 12 Volt Conversion Guide: Owners of old cars and trucks that came with 6 volt electrical systems know what  How to Run in a New Engine: The following procedures assume that proper assembly and installation procedures have been followed for rebuilding and Note: These links are to other sites where other people have taken the time to do the work.  I give them full credit for this information, nd if one of these is your work, please e-mail me if you would like the link removed. Discussions | Clubs & Events | How To's | Classifieds | Suppliers | Photo Galleries | Featured Page | Reader's Pages Return Home